Panasonic KX-TG5240AL - Manual (Page 92)

Troubleshooting
92
Caller ID information is not
displayed during message
playback (p. 69). • Caller ID information will not be displayed
— if a message is recorded by using [MEMO]
(p. 71), or
— if a call is transferred to a mailbox and the
caller leaves a message (p. 72).
You cannot remember your
mailbox password. You cannot
retrieve the messages from
your mailbox. • Confirm the mailbox password using the
handset (p. 65).
• If you cannot use the handset, you can
retrieve the messages from your mailbox after
erasing the password, using the base unit;
Press [PROGRAM], [MUTE], [#], and
[9][0][0][0].
Please note that the following settings will
return to the factory preset with the Mailbox 2
and 3 passwords.
• You cannot reset the above settings to the
factory preset, if the dial lock is turned on
(p. 62). If you forget your password of dial
lock, consult your nearest Panasonic service
centre.
Problem Cause & Remedy
Function Factory preset
Date & time —
Recall time 100ms
Line mode B mode
Answering System On
Number of rings 4
Recording time 3 min
Remote code 11
Recording mode Standard (16 min)
Base unit ringer volume High
Base unit ringer tone Tone 1
Base unit incoming call tone 2
Base unit room monitor mode Off
Base unit Talking Caller ID
On
TG5240AL.fm Page 92 Friday, June 11, 2004 5:22 PM