Panasonic AJ-HDC27FP - Manual (Page 56)

56
Setting the electronic shutter
Changing the shutter speed
and mode selection range
1
Perform the menu operations (pages 84 to 86),
and display the “SHUTTER SPEED” screen.
4
Press the MENU button to exit the menu
operations.
The setting menu is cleared, and the displays
showing the unit’s current statuses appear at the
top and bottom of the viewfinder screen.
<Notes>
O
When operating the unit from the AJ-EC3 extension
control unit (optional accessory), the shutter speed
selected by the AJ-EC3 switch will take precedence
in determining the actual shutter speed even when
operations have been performed on the unit’s
SHUTTER SPEED screen.
O For details on selecting the engineer mode and
display screens, refer to “Menu operations” (pages
84 to 86).
On the SHUTTER SPEED screen of FILM (CAM)
MAIN MENU 2, the setting range of the shutter speed
can be restricted to the required range and whether or
not to use the special operation mode (SYNCHRO
SCAN) can be selected.
2
Turn the JOG dial button to move the arrow
(cursor) to the desired item.
3
Press the JOG dial button to set the item to be
changed.
Turn the JOG dial button to select ON or OFF, and
press the button to enter the setting.
n < SHUTTER SPEED >
SYNCHRO SCAN 1 :ON
SYNCHRO SCAN 2 :OFF
POSITION 1 :ON
POSITION 2 :ON
POSITION 3 :ON
POSITION 4 :ON
POSITION 5 :ON
POSITION 6 :ON
POSITION1 POSITION2
SYNCHRO SCAN 1 SYNCHRO SCAN 2
POSITION3 POSITION4 POSITION5 POSITION6
Setting the shutter mode and
speed
1
Following the steps for “Switching the display
mode” (page 46), set DISP MODE to “2” or “3” on
the VF DISPLAY screen of FILM (CAM) MAIN
MENU 2.
SHUTTER switch
Example: “1/120,” “50.0%,” etc.
2
Press the SHUTTER switch from ON to SEL.
The current shutter setting appears on the setting
change message display area of the viewfinder
screen.
Fixed mode
3
Press the SHUTTER switch to the SEL position
again, and repeat this until the desired mode or
speed is displayed.
When all the modes and speeds are displayed, the
display will change in the sequence shown below.
When the required shutter speed and mode have
been assigned beforehand, only the assigned
speed or mode will be displayed.
O The SHUTTER switch is used to set the shutter
speed and the shutter speed in the fixed mode.
O
The shutter speed in the SYNCHRO SCAN mode
can easily be changed using the SYNCHRO (“+”
and “–”) buttons.
O
On the SHUTTER SPEED screen of FILM (CAM)
MAIN MENU 2, the setting range of the shutter
speed can be restricted to the required range and
whether or not to use the special operation mode
(SYNCHRO SCAN) can be selected.