Panasonic AJ-HDC27FP - Manual (Page 57)

57
Setting the electronic shutter
Switching the shutter speed
display
The unit enables the SYNCHRO SCAN mode to be
displayed on the viewfinder screen to be switched to
“1/
¢¢¢ (sec.),” “ ¢¢¢ %” or “ ¢¢¢ d (angle)” on the
VF DISPLAY screen of FILM (CAM) MAIN MENU 2.
1
Perform the menu operations (pages 84 to 86),
and open the VF DISPLAY screen.
2
Turn the JOG dial button to move the arrow
(cursor) to the SYNCHRO SCAN DISP. item.
3
Press the JOG dial button to set the SYNCHRO
SCAN display mode.
Turn the JOG dial button, select the display, and
then press the JOG dial button to enter the
selection.
sec (seconds) : 1/ ¢¢¢
% : ¢¢¢ %
deg (angle) : ¢¢¢ d
e.g.
When the frame rate is set to 24 fps and exposure
time is set to half:
1/48 sec = 50% = 180 deg.
4
Press the MENU button to exit the menu
operations.
The setting menu is cleared, and the displays
showing the unit’s current statuses appear at the
top and bottom of the viewfinder screen.
n < VF DISPLAY >
DISP CONDITION :NORMAL
DISP MODE :3
VF OUT :Y
VF DTL :4
ZEBRA1 DETECT :070%
ZEBRA2 DETECT :085%
ZEBRA2 :SPOT
LOW LIGHT LVL :45%
SYNCHRO SCAN DISP.:deg
ECU MENU DISP. :ON
< VF DISPLAY >
DISP CONDITION :NORMAL
DISP MODE :3
VF OUT :Y
VF DTL :4
ZEBRA1 DETECT :070%
ZEBRA2 DETECT :085%
ZEBRA2 :SPOT
LOW LIGHT LVL :45%
n SYNCHRO SCAN DISP.:deg
ECU MENU DISP. :ON
Setting the synchro scan mode
2
In the SYNCHRO SCAN mode, continuous
switching inside the 3.0 deg to 350.0 deg (0.8% to
97.2%) range can be achieved by pressing the
SYNCHRO (“+” and “–”) buttons.
SHUTTER switch
1
Press the SHUTTER switch from ON to SEL and
set to SYNCHRO SCAN.