Panasonic AJ-HDC27FP - Manual (Page 61)

61
Adjusting the audio level
When the AUTO SELECT CH1 and CH2 selector
switches are set to AUTO, the audio CH1 and CH2
input levels are adjusted automatically.
Proceed as follows to adjust the audio channel 1 and
2 levels manually.
Manual audio level adjustments
When the audio levels have been adjusted manually,
the limiter circuit is tripped by an excessively high
input level. This circuit can be turned ON or OFF on
the MIC/AUDIO screen of the VTR menu.
(The factory setting is OFF.)
Limiter
1
Set the AUTO SELECT CH1 and CH2 selector
switches to MAN. AUTO SELECT CH1
selector switch
AUTO SELECT CH2
selector switch
AUDIO LEVEL
CH1 control
AUDIO LEVEL
CH2 control
2
Adjust the AUDIO LEVEL CH1 and CH2 controls in
such a way that, when audio signals are input, the
level meter reading will not exceed 0 dBu even
under maximum signal input level conditions.
Scan reverse
Using an HD lens adapter made by Angenieux, this
unit supports the ultra-prime lenses used for film
cameras as a standard feature. Furthermore, it can
also select the setting of the scan reverse function for
canceling the image correction (reversal of the
top/bottom and left/right of the images) that is
performed when this adapter is used.
Setting the scan reverse
1
Perform the menu operations (pages 84 to 86),
and display the “FRAME MODE” screen of FILM
(CAM) MAIN MENU 2.
2
Turn the JOG dial button to move the arrow
(cursor) to the “SCAN REVERSE” item.
3
Press the JOG dial button, and set the desired
scan reverse.
Turn the JOG dial button, ON or OFF and press
the JOG dial button to enter the selection.
4
Press the MENU button to exit the menu
operations.
The setting menu is cleared, and the displays
showing the unit’s current statuses appear at the
top and bottom of the viewfinder screen.
n < FRAME MODE >
FRAME RATE RANGE:60-12
FRAME RATE :24
SCAN REVERSE :OFF