Proxim ORiNOCO AP-2500 - Manual (Page 195)

195
Using the Command Line Interface
Example 6 - Show Individual and Table Parameters
1. View a single parameter
Syntax:
[Device Name]>show <parameter name>
Example:
[Device Name]>
show ipaddr
Result: Displays the Access Point IP Address.
Figure A-10 Result of “show ipaddr” CLI Command
2. View all parameters in a table
Syntax:
[Device Name]> show <table name>
Example:
[Device Name]>
show mgmtipaccesstbl
Result: Displays the IP Access Table and its entries.
Using Tables & User Strings
Working with Tables
Each member of the table must be specified, as in the example below.
[Device Name]>set mgmtipaccesstbl 0 ipaddr 10.0.0.10 ipmask 255.255.0.0
The following are the rules for creating, modifying, enabling/disabling, and deleting table entries for the first table
syntax.
•
Creation
–
The table name is required.
– The table index is required – for some tables (such as mgmtipaccesstbl), to create an instance the index is
always zero (0). For other tables (such as secenckeylentbl), you need to specify the index number.
– The order in which the table arguments or objects are entered in not important.
– Parameters that are not required can be omitted, in which case they will be assigned the default value as
specified in the MIB or product functional specification document.
• Modification
–
The table name is required.
– The table index is required – for table modification the index should be the index of the entry to be modified.
– Only the table objects that are to be modified need to be specified. Not all the table objects are required.
– If multiple table objects are to be modified the order in which they are entered is not important.
– If the entire table entry is to be modified, all the table objects have to be specified.
• Enabling/Disabling
–
The table name is required.
– The table index is required – for table enabling/disabling the index should be the index of the entry to be
enabled/disabled.
– The reserved word enable or disable are required.