Proxim ORiNOCO AP-2500 - Manual (Page 199)

199
Using the Command Line Interface
Figure A-11 Result of “show system” CLI Command
Set Static IP Address for the AP-2500 device
[Device Name]>set ipaddrtype static
[Device Name]>set ipaddr <fixed IP address of unit>
[Device Name]>set ipsubmask <IP Mask
(default = 255.0.0.0)>
[Device Name]>set ipgw <gateway IP address (default = 10.0.0.1)>
[Device Name]>show network<CR>
NOTE
The IP Mask of the AP-2500 unit needs to match the IP Mask of your network.
Set a Network Name for each Wireless Interface
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif 3 netname <Network Name (SSID) for wireless card in Slot A>
[Device Name]>set wif 4 netname <Network Name (SSID) for wireless card in Slot B>
[Device Name]>show wif<CR>