Snmp parameters, Snmp table host table parameters, Telnet parameters – Proxim ORiNOCO AP-2500 User Manual
Page 213: Using the command line interface, Snmp parameters snmp table host table parameters
213
Using the Command Line Interface
SNMP Parameters
SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the “comment” argument.
Telnet Parameters
Name
Type
Values
Access
CLI Parameter
SNMP
Group
N/A
R
snmp
SNMP Management
Interface Bitmask
Interface Bitmask
0 - no interfaces
(disable)
1 - Ethernet
4 - Wireless A
8- Wireless B
15 - all interfaces
RW
snmpifbitmask
Read Password
DisplayString
User Defined
public (default)
max 63 characters
W
snmprpasswd
Read/Write Password
DisplayString
User Defined
public (default)
max 63 characters
W
snmprwpasswd
SNMP Trap Host Table
N/A
N/A
R
snmptraphosttbl
Name
Type
Values
Access CLI Parameter
SNMP Trap Host Table
Table
N/A
R
snmptraphosttbl
Table Index
Integer
User Defined
N/A
index
IP Address
IpAddress
User Defined
RW
ipaddr
Password
DisplayString
User Defined
W
passwd
Comment (optional)
DisplayString
User Defined
RW
cmt
Status (optional)
Integer
enable
disable
delete
RW
status
Name
Type
Values
Access
CLI Parameter
Telnet
Group
N/A
R
telnet
Telnet Management
Interface Bitmask
Interface Bitmask
0 - no interfaces
(disable)
1 - Ethernet
4 - Wireless A
8- Wireless B
15 - all interfaces
RW
telifbitmask
Telnet Port
Integer
User Defined
23 (default)
RW
telport
Telnet Login Inactivity
Time-out
Integer
1 – 60 seconds
30 sec (default)
RW
tellogintout
Telnet Session Idle
Time-out
Integer
1 - 900 seconds
900 sec (default)
RW
telsessiontout