Panasonic AG-HPX300P - Manual (Page 128)

1
Chapter

Men
uOper
ations
SW MODE screen
Item Setting Notes
LOW GAIN Sets the gain value assigned to the L position of the
GAIN switch.
–3dB, 0dB, 3dB, 6dB, 9dB, 12dB
MID GAIN Sets the gain value assigned to the M position of the
GAIN switch.
–3dB, 0dB, 3dB, 6dB, 9dB, 12dB
HIGH GAIN Sets the gain value assigned to the H position of the
GAIN switch.
–3dB, 0dB, 3dB, 6dB, 9dB, 12dB
ATW Allows you to assign the ATW (Auto Tracking White
Balance) function to the WHITE BAL switch. (For
details, refer to page 50.)
Bch:
Controls the ATW function when the WHITE BAL
switch is set to B position.
OFF:
Does not assign the ATW function to the WHITE
BAL switch.
• A USER button to which ATW has
been assigned cannot be used to turn
ATW off when the WHITE BAL switch is
set to B position and this menu is set
to Bch.
ATW TYPE Selects type of ATW (Auto Tracking White Balance)
function operation.
1:
Standard ATW operation
2: Further restricts the color of the light source range
that is tracked than setting 1.
ATW operation reduces the risk of miscalculating light
sources.
W.BAL.PRESET Sets the color temperature assigned to the PRST
position of the WHITE BAL switch.
3.2K, 5.6K
USER MAIN Sets the function assigned to the USER MAIN button.
REC REVIEW, SPOTLIGHT, BACKLIGHT, ATW,
ATWLOCK, GAIN: 24 dB, Y GET, DRS, TEXT MEMO,
SLOT SEL, SHOT MARK, MAG A. LVL, PRE REC,
PC MODE, WFM
For details, refer to [Assigning functions to USER
buttons] (page 53). • When a remote controller (AJ-RC10G)
is connected, the SPOTLIGHT
and BACKLIGHT functions are not
available.
USER1 Sets a function assigned to the USER1 button. The
functions that can be assigned to this button are the
same as for the USER MAIN button.
BACKLIGHT
(factory default setting)
For details, refer to [Assigning functions to USER
buttons] (page 53).
USER2 Sets a function assigned to the USER2 button. The
functions that can be assigned to this button are the
same as for the USER MAIN button.
TEXT MEMO
(factory default setting)
For details, refer to [Assigning functions to USER
buttons] (page 53).
RET SW Sets the function assigned to the RET button on the
lens.
REC REVIEW, TEXT MEMO, SHOT MARK
WFM Selects the waveform displayed in the LCD monitor
when the user button to which WFM has been
assigned is pressed.
WAVE:
Displays a waveform.
VECTOR: Vectorscope display
WAVE/VECT: Each press of the button, switches
the settings in the following order: OFF  WAVE
(waveform)  VECTOR  OFF.
____ indicates the factory setting