Panasonic AG-HPX300P - Manual (Page 17)

1
Chapter

P
ar
ts
and
their
Functions
Audio (output) Function Section
1
5 7
3 4
2 6
1 MONITOR SELECT (audio channel) CH1/2, CH3/4
selector switch
Use this switch to select the audio channel whose
signals are output to the speaker, earphones or AUDIO
OUT connectors.
CH1/2:
Signal output of audio channels 1 and 2.
CH3/4: Signal output of audio channels 3 and 4.
The channel indications of the audio level meters in the
viewfinder and on the LCD monitor show the channels
selected with this switch.
2 MONITOR SELECT (audio selection) CH1/3, ST,
CH2/4 selector switch
This switch and the MONITOR SELECT CH1/2, CH3/4
switch select the audio signal output to the speaker,
earphones and AUDIO OUT connectors.
MONITOR SELECT
switch (left)
MONITOR SELECT switch (right)
CH1/2 CH3/4
MONITOR
SELECT
CH1/3 Audio Channel 1 Audio Channel 3
ST
Stereo signals
from Audio
Channels 1 and 2 *1
Stereo signals
from Audio
Channels 3 and 4 *1
CH2/4 Audio Channel 2 Audio Channel 4
*1 MIX in the menu option MONITOR SELECT in the
AUDIO SETUP screen allows you to change stereo
signals to a mixed signal.
3 MONITOR (volume) control
Use to control the alarm sound volume and volume of
sound output from the monitor speaker and earphones.
4 Speaker
The speaker outputs EE sound during recording and
reproduced sound during playback. The speaker emits
an alarm sound when the warning lamp and indicator
light or blink. EE sound and reproduced sound are not
output during alarm sound output.
When earphones are connected to the PHONES
connector, the sound from the speaker is automatically
muted.
5 PHONES (earphones) jack (mini jack)
This connector is designed for audio monitoring (stereo)
earphones.
6 DC OUT (DC power supply) output socket.
This is a 12 V DC output socket that provides a
maximum current of 1.5 A.
 NOTE
Be sure to check polarity before connecting an external
device as incorrect connection could lead to damage.
7 AUDIO OUT connector
• This connector outputs audio signals recorded on
audio channels 1/2 and 3/4.
• Use the MONITOR SELECT CH1/2, CH3/4 selector
switch to select output signals.