Panasonic AG-HPX300P - Manual (Page 82)


Chapter

Adjustments
and
Settings
for
Recording
The card will not be formatted if the following message
appears when the JOG dial button is pressed:
Error message Remedy
SD CARD FORMAT NG
NO CARD
(No SD memory card
inserted.)
Insert an SD memory card.
SD CARD FORMAT NG
ERROR
(SD memory card cannot be
formatted.)
The card may be defective.
Replace the card.
SD CARD FORMAT NG
WRITE PROTECT
(SD memory card is write-
protected.)
Remove the card and
cancel the protect.
SD CARD FORMAT NG
CANNOT ACCESS
(SD memory card not
accessible).
The SD memory card is
not accessible. When the
current access operation
ends, reformat the card.
How to Use Scene File Data
• Each position of the SCENE FILE dial stores settings for
specific shooting situations.
• When shooting, you can retrieve the necessary file
instantly using scene file dial.
• You can also use menu options to change set scene file
values. A modified scene file can be saved to each scene
file dial position.
SCENEFILEdial
• Note that changing scene files during recording will
not change VFR and frame rate settings. To make such
changes, set the camera to recording standby status.
 Factory setting
•F1:SCENE
File suitable for normal shooting.
•F:SCENEFLUO.
File suitable for shooting under fluorescent lights, ie.
indoors.
•F:SCENESPARK
File suitable for SD shooting with a greater range of
resolution, coloring and contrast.
•F:SCENEB-STR
File for increasing the contrast of dark areas, such as
when shooting sunsets.
•F:SCENECINEV
File suitable for shooting movie-like scenes where the
contrast is to be emphasized.
•F:SCENECINED
File suitable for shooting movie-like scenes where the
dynamic range is to be emphasized.
 NOTE
Changes to scene files do not affect SYSTEM MODE settings.
Use the SYSTEM SETUP screen to make such changes.