NISSAN CVT SIC0697 - Manual (Page 111)

BATTERY REPLACEMENT
Replace the battery as follows:
1. Open the lid using a suitable tool.
2. Replace the battery with a new one.
Recommended battery: Sanyo CR2025 or
equivalent
Make sure that the
⊕ side faces the
bottom case.
3. Close the lid securely.
4. Push the keyfobbutton two or three times to
check its operation.
See your NISSAN dealer if you need any assis-
tance for replacement.
If the battery is removed for any reason
other than replacement, perform the step 4
above.
¼ Be careful not to touch a circuit board
and a battery terminal.
¼ An improperly disposed battery can
harm the environment. Always confirm
local regulations for battery disposal.
¼ The keyfob is water-resistant; however,
if it does get wet, immediately wipe
completely dry.
¼ When changing batteries, do not let
dust or oil get on the keyfob.
FCC Notice:
Changes or modifications not expressly
approved by the manufacturer compliance
could void the user’s authority to operate
the equipment. This device complies with
Part 15 of the FCC Rules and RSS-210 of
Industry Canada. Operation is subject to
the following two conditions: (1) This de-
vice may not cause harmful interference,
and (2) this device must accept any inter-
ference received, including interference
that may cause undesired operation of the
device.
SPA1374
3-8 Pre-driving checks and adjustments
੬ 04.4.5/Z50-D/V5.0 ੭