NISSAN CVT SIC0697 - Manual (Page 128)

HOW TO USE “MAINT”
(Maintenance) BUTTON
Pushing the “MAINT” button will change the
maintenance menu as follows:
ENGINE OIL
→ TIRE ROTATION → TIRE
PRESSURE (if so equipped)
To reset the driving distance, push the “MAINT”
button or “TRIP RESET” button for more than
approximately 1.5 seconds.
To set the distance, push the joystick to left or
right.
Tire pressure information (if so
equipped)
Pressure indication in ** psi on the screen
indicates that the pressure is being measured.
After a few driving trips, the pressure for each
tire will be displayed randomly.
The order of tire pressure figures displayed on
the screen does not correspond with the actual
order of the tire position.
Tire pressure rises and falls depending on the
heat caused by the vehicle’s traveling condition
and the temperature.
In case of flat tire, a message (FLAT TIRE or
CHECK ALL TIRE) is displayed on the screen:
FLAT TIRE — very low tire air pressure.
WARNING
When a spare tire is mounted or a wheel
is replaced, the pressure of that tire will
not be indicated and not be monitored
by the low tire pressure warning system.
Contact your NISSAN dealer as soon as
possible for tire replacement and/or
system resetting.
HOW TO USE “SETTING” BUTTON
Pushing the “SETTING” button will change the
settings menu as follows:
k 1 DISPLAY ON/OFF
k 2 LANGUAGE
k
3 BEEP SET
k 4 SERVICE ALERT
k
5 PERSONALIZED SETTINGS MENU
SAA0646 SAA0798
Display screen, heater, air conditioner and audio systems 4-5
੬ 04.4.5/Z50-D/V5.0 ੭