NISSAN CVT SIC0697 - Manual (Page 238)

Tire and loading information label
k
1 Seating capacity: The maximum number of
occupants that can be seated in the vehicle.
k 2 Vehicle load limit: See loading information in
the Technical and consumer information sec-
tion.
k
3 Original tire size: The size of the tires origi-
nally installed on the vehicle at the factory.
k
4 Recommended cold tire inflation pressure:
Inflate the tires to this pressure when the tires
are cold. Tires are considered COLD after
the vehicle has been parked for 3 or more
hours, or driven less than 1 mile (1.6 km) at
moderate speeds. The recommended cold
tire inflation is set by the manufacturer to
provide the best tire wear and vehicle han-
dling characteristics based on the vehicles
GVWR.
k 5 Tire size — refer to “Tire labeling” later in this
section.
k 6 and k 7 Spare tire size or compact spare tire
size (if so equipped)
Checking the tire pressure
1. Remove the valve stem cap from the tire.
2. Press the pressure gauge squarely onto the
valve stem. Do not press too hard or force the
valve stem sideways, or air will escape. If the
hissing sound of air escaping from the tire is
heard while checking the pressure, reposition
the gauge to eliminate this leakage.
3. Remove the gauge.
4. Read the tire pressure on the gauge stem
and compare it to the specification shown on
the Tire and Loading Information label.
5. Add air to the tire as needed. If too much air
SDI1574
Maintenance and do-it-yourself 8-29
੬ 04.4.5/Z50-D/V5.0 ੭