Nortel Networks M3310 - Manual (Page 220)

220 Digital Telephone IP Adapter Installation and Administration Guide
Troubleshooting Standard 2.1
Software problems
This section identifies some problems that can occur with the Configuration
Manager software, and describes what to do to resolve them.
Symptom descriptions
If you are not able to complete a task with the Configuration Manager, perform
troubleshooting as described in the following table.
Display Logs definitions
You can locate Display Logs definitions in Configuration Manager Help.
Symptom What to do
10060 TELNET CONNECTION
FAILED
appears when attempting
to connect to the Digital
Telephone IP Adapter unit.
It is possible that communication has been
lost between the administration PC and the
Digital Telephone IP Adapter unit.
Close the Configuration Manager, then
restart it.
The Digital Telephone IP
Adapter unit does not send or
receive Ethernet traffic. It is possible that communication has been
lost between the administration PC and the
node you were logged on to.
Close the Configuration Manager, then
restart it.