Nortel Networks M3310 - Manual (Page 84)

84 Digital Telephone IP Adapter Installation and Administration Guide
Configuring the IP Adapter unit using the telephone menu Standard 2.1
Before you begin
To complete initial configuration of the Digital Telephone IP Adapter unit, you
must use the telephone menu. After initial configuration, you can use
Configuration Manager for changes, administration, and firmware upgrades. For
a more detailed description of Configuration Manager, refer to the Reach Line
Card Installation and Administration Guide (NTP 555-8421-210).
Note: You cannot access the telephone menu and Configuration Manager at the
same time. You must use one or the other. If you want to use Configuration
Manager to configure the Digital Telephone IP Adapter unit, refer to Chapter 5,
“Changing configuration settings using Configuration Manager”.
Information you need to know before configuring
Before you start configuring the Digital Telephone IP Adapter unit, have the
following information available:
!
the unit ID for the Digital Telephone IP Adapter unit
!
the online and offline SPRE codes
!
the registration and deregistration SPRE codes
!
an IP address, including subnet mask and the IP address of the IP Gateway,
if applicable
The network administrator can provide the above information to the end-user by
filling out and delivering the Telephone Menu - Configuration Values form in
Appendix A, “Planning forms.”