ZANKER KBT 23001 SB User Manual

Page 20

Advertising
background image

Problem

Possible cause

Solution

Food placed in the appliance was
too warm

Allow food to cool to room temperature
before storing

The temperature of the room that
contains the appliance is too high for
efficient operation

Try to reduce the temperature in the
room where the appliance stands

Water flows at the back plate
of the refrigerator

During automatic defrosting, frost
melts on the back plate

It is normal

Water flows into the refrigera-
tor compartment

The outlet can be clogged up

Clean the outlet

Products placed in can prevent water
from flowing into the collector

Replace the products so that they can
not touch the back plate directly

Water flows onto the floor

The melting water outlet flows not in-
to the evaporative tray above the
compressor

Put the melting water outlet to the
evaporative tray

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the lamp".

It is too warm in the refrigera-
tor

The Temperature Regulator may be
set incorrectly

Set a lower temperature

The door does not close tightly or it
is not shut properly

Check if the door closes well and the
gasket is undamaged and clean

Food placed in the appliance was
too warm

Allow food to cool to room temperature
before storing

Large quantities of food to be cooled
were put in at the same time

Insert smaller quantities of food to be
cooled at any one time

There is no inside cool air circulation Provide inside cool air circulation

It is too cold in the refrigera-
tor

The Temperature Regulator may be
set incorrectly

Set a higher temperature

There is too much frost and
ice

Products are not wrapped properly

Wrap the products better

Doors are not shut properly or do not
close tightly

Check if the doors close well and the
gaskets are undamaged and clean

The Temperature Regulator may be
set incorrectly

Set a warmer temperature

It is too warm in the freezer

Temperature Regulator may be set
incorrectly

Set a lower temperature

The door does not close tightly or it
is not shut properly

Check if the door closes well and the
gasket is undamaged and clean

Large quantities of food to be frozen
were put in at the same time

Insert smaller quantities of food to be
frozen at any one time.

20

Advertising