Nvidia 4 - Manual (Page 141)

NVIDIA Corporation 137
C HAPTER 4
Initializing, Rebuilding, and Synchronizing RAID Arrays
Synchronizing a RAID Array
Synchronizing an array will force a rebuild of redundancy or parity. The operation is
applicable to any fault tolerant array such as RAID 1, 0+1 and RAID 5.
• For RAID1 and RAID 0+1, “sync” results in copying the data to the redundancy disk,
• For RAID 5, “sync” results in rebuilding the parity
To sync an array, do the following (This example assumes you have already created a
fault tolerant array such as RAID 1):
1 Right click on “Mirroring” and select Synchronize Array as shown in Figure 4.15 .
Figure 4.15 Array Pop-up Menu
The Synchronize Array Wizard Welcome screen appears.