Nortel Networks NN43001-504 - Manual (Page 125)

Dropped calls 125
Wireless handset status messages
Wireless handset status messages provide information about the handset
communication with the AP and Call Server.
Table 16 "Wireless handset
status messages" (page 125) summarizes the status messages, in
alphabetical order.
Table 16
Wireless handset status messages
Message Description Action
3 chirps Wireless handset is not able to
communicate with the best AP,
probably because that AP has
no bandwidth available. None. This is only a warning.
The call is handed-off to the
best AP after it becomes
available.
Address Mismatch Wireless handset software
download files are incorrect or
corrupted. Download new software from
the Nortel site.
See
"Updating software" (page
114) .
ASSERT xxx.c
Line yyy
(For WLAN Handsets
2210/2211/2212 only.) The handset has detected
a fault from which it cannot
recover. Record the error information so
that it can be reported.
Turn the handset off, and then
on again.
If the error persists, try
registering a different handset
to this telephone port.
If the error still persists, contact
Nortel Technical Support and
report the error.
Assoc Failed
xxxxxxxxxxxx x...x = AP MAC address
Handset association is refused
by the AP; displays the MAC of
the failing AP. Check the handset and AP
security settings.
Ensure that the AP
is configured per the
Configuration Note.
Try another AP.
Assoc Timeout
xxxxxxxxxxxx x...x = AP MAC address
Handset did not receive an
association response from the
AP; displays the MAC of the
failing AP. Check the handset and AP
security settings.
Ensure that the AP
is configured per the
Configuration Note.
Try another AP.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.