Nortel Networks NN43001-504 - Manual (Page 203)

Diagnostic Tools 203
When you select Any SSID mode, the summary display contains the first
six characters of the APs SSID instead of the beacon interval, as shown in
the following example.
ab7b -28 02
2ae5 -48 06
2ae5 -56 11
Any
ALPHA
WSMTES
voice
Detl
In detail mode, the display appears as follows. The left and right arrow keys
move between AP indices.
i:bbbbb sn ch bcn
eeeeeeeeeee DGHI
rrrrrrrrrrrrr+xxxx
mmm G:gggg P:pppp
Any Smry
where
i = index of selected AP (value is from 0 to 3 inclusive)
bbbbb = last three octets of the SSID for a discovered AP
sn = signal strength in -dBm
ch = channel
bcn = beacon interval
eeeeeeeeeee = SSID (up to first 11 characters)
DGHI = standards supported
rrrrr = rates supported—basic rates have a b following the rate
+ = more rates supported than displayed
xxxx = WMM or UPSD if supported
mmmm = security mode
G:gggg = group key security
P:pppp = pair-wise key security
Any/MyID = soft key to toggle between single and multiple SSID mode
Detl/Smry = soft key to toggle between the multiple AP display
(summary) and the single AP display (detail)
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.