Network Technologies DVB-ASI to IP - Manual (Page 12)

ASI-IP-GTW User's Manual
Page 12
1.5 Guided Tour
1.5.1 The User Interface
All connectors are provided at the rear panel. Configuration and
monitoring of the unit is performed via a FLASH-based WEB interface
using a standard WEB browser such as Internet Explorer. The unit also
supports configuration via file transfer of XML files. Once configured,
the unit runs without the need for further intervention unless system
configuration requirement change.
1.5.2 Front Panel Description
The front panel provides four LEDs per ASI-IP-GTW. Table 1 describes
the meaning of the different LED indicators.
Table 1. Front panel LEDs
1.5.3 Rear Panel Description
All connectors to the ASI-IP-GTW are provided at the rear panel. Figure
3 shows the rear panel of a ASI-IP-GTW equipped with 4 DVB-ASI
connectors.
1. ASI. In IP TX mode, the connector provides a DVB-ASI input. In IP
Rx mode, the connector provides a DVB-ASI output.
2. Management port. The ASI-IP-GTW provide one Ethernet port for
control and management of the unit.
3. Ethernet data port. The ASI-IP-GTW provides one Ethernet data
port for high speed signal transmission and reception.
4. Alarm/RS232 Connector. This 9-pin male D-SUB connector
provides RS232 access and alarm information.
5. Technical Earth. The ASI-IP-GTW provide a Technical Earth.
6. Mains Power Connection. This is the Power Supply Connection.
Indicator Colour Description
Power Green This LED is lit when power is being received by the
unit.
Alarm Red This LED is lit when a failure is detected by the unit.
IP TX Blue This LED is lit when the unit is configured to transmit
data to the IP Network.
IP RX Yellow This LED is lit when the unit is configured to receive
data from the IP Network