Network Technologies DVB-ASI to IP - Manual (Page 31)

ASI-IP-GTW User's Manual
Page 31
1.1.1.21 Advanced
The advanced sub-tab of the Data interface allows configuration of in-
band management.
Figure 9. The device info, network and advanced sub-page
Allow ping response: Tick this box to filter incoming ICMP messages. If
this option is not enabled, the device will not answer to ping requests
on the data port.
Allow in-band management: Tick this box to allow management traffic
on the data port.
Use as default management interface: Tick this box to use the data
port as the default management interface. Enabling this option will
force management traffic to IP addresses not matching either of the
sub-nets of the two interfaces, to the data interface. Note that this
means you will only be able to reach the device through the
management interface if you are located at its sub-net.
Multicast router: The IP address of the multicast router. The address
here is used in conjunction with the “use multicast router” option on
the IP TX page. (see chapter 3.6.1). This parameter is only showed on
units configured for IP transmission.
IGMP version: The default IGMP version to use. This parameter is only
showed on units configured for IP reception. There is limited support
for IGMP version 2 and 3. IGMP version 3 is limited to INCLUDE mode,
one source only per channel, with no automatic fallback to IGMP
version 2.
1.1.1.22 SFP