Network Technologies DVB-ASI to IP - Manual (Page 30)

ASI-IP-GTW User's Manual
Page 30
When the bi-directional feature is enabled, a third option ‘ASI <--> IP’ is
available to operate half of the ASI connectors as inputs and the other
half as outputs.
Note that a mode switch requires a device re-boot, this is done
automatically when pressing OK in the confirmation window that is
displayed when a new mode is selected.
Reset device: Press this button to perform a soft reset of the device. An
alert is displayed, with an option to cancel, before the reset message is
sent to the box.
On the lower part of the Device info page, three sub-pages are available:
Network, Time settings and Alarms.
3.5.1 Network
On Network sub-page the management interface and the Ethernet data
interface is configured. For each of the interfaces the following
information is configured:
1.1.1.20 Main
IP address: The IP address entered as four decimal triplets separated
by decimal points (full stop/period) e.g. 10.40.81.120.
Sub mask: The subnet mask entered as four decimal triplets separated
by decimal points (full stop/period) e.g. 255.255.255.0.
Default gateway: The IP address of the default gateway entered as four
decimal triplets separated by decimal points (full stop/period) e.g.
255.255.255.0.
Speed/duplex mode: The speed and mode of the management
interface: Auto 10/100Mbps, Auto 10Mbps, Fixed 100Mbps-full duplex,
Fixed 10Mbps-full duplex, Fixed 100Mbps-half duplex and Fixed
10Mbps-half duplex.
Remark that switching to a mode that is not compatible with the peer
side may cause you to loose connection with the device. Remark also
that in the fixed modes, the auto straight-through or crossover cable
detection is disabled, so you have to use the right type of cable.
MAC address: The MAC address is displayed.
For the Data interface the following is also possible to configure the
following on the main tab:
Media select: This field is only shown if the unit is equipped with an
optional SFP slot. Select "Built-in RJ-45" to use the data port marked
Data for data traffic. Select "SFP" to use the SFP module for data traffic.
Speed/duplex mode: The speed of the data interface: Auto
10/100/1000Mbps, Auto 10/100Mbps, Auto 10Mbps, Fixed 1000Mbps
-full duplex, Fixed 100Mbps-full duplex, Fixed 10Mbps-full duplex,
Fixed 100Mbps-half duplex and Fixed 10Mbps-half duplex.
Furthermore the same remarks apply as for the management port.