6 powering up/down, 1 before powering up, 2 powering up – Network Technologies DVB-ASI to IP User Manual

Page 24: 3 powering down, Powering up/down, Before powering up, Powering up, Powering down

Advertising
background image

ASI-IP-GTW User's Manual

Page

24

Table 10. ASI port LEDs


Each Ethernet port (data and management) has two LEDs associated
with it.

Table 11. Ethernet port LEDs

2.6 Powering Up/Down

2.6.1 Before Powering up

Before powering-up the unit, please check the following:

o

The unit is installed in a suitable location

o

The unit has been connected to external equipment as required

2.6.2 Powering Up

Power up the unit by inserting the power cable connected to a power
source.
The cooling fans will start up in a full-speed mode. When the unit has
finished the start-up procedure, the fans will run at normal speed.
Please check that the all cooling fans are rotating. If they are not,
switch of the unit immediately.

2.6.3 Powering Down

To power down the unit, remove the power supply connection at the
rear of the unit.

Mode

ASI Rx

Active

Description

Unlit Unlit Input

disabled (ASI input)

Lit

Unlit

Input enabled, no ASI stream detected (not in
sync)

IP Tx

Lit

Lit

Input enabled, ASI stream detected (in sync)

Unlit Unlit Output

disabled (ASI output)

IP Rx

Unlit Lit

Output

enabled

Traffic and link indicator

Description

Green Lit

when

link

Blinks when data is transmitted or received.

Speed indicator

Description

Unlit 10Mbit/s

Green 100Mbit/s

Yellow 1000Mbit/s

Advertising