Network Technologies DVB-ASI to IP - Manual (Page 62)

ASI-IP-GTW User's Manual
Page 62
Metric on clear: The metric number to be used in the RIP messages
when there are no active alarms in the unit.
Metric on critical: The metric number to be used in the RIP messages
when there are at least one critical alarm present.
Destination: The IP destination address to use for the RIP messages.
Enable manual next hop: If set, the RIPv2 messages will specify the
next hop as defined in the “Next hop address” field.
Next hop address: The address to be used for the next hop.
Route tag: Corresponds to the route tag field in the outgoing RIP
messages.
Update interval: Specifies the average update interval for the RIPv2
messages. Note that the ASI-IP-GTW adds some random delay to avoid
sending messages too regularly.
The status parameters are:
RIP-2 message count: Shows the number of RIP-2 messages
transmitted.
Current metric: Shows the current metric used in the outgoing RIP-2
messages. Will be either the “Metric on clear” or the “Metric on critical”
value.
Next hop: Shows the next hop value.