National Instruments PCI-6110E/6111E User Manual
Page 100
Glossary
© National Instruments Corporation
G-7
mV
millivolts
N
NC
normally closed, or not connected
NI-DAQ
National Instruments driver software for DAQ hardware
noise
an undesirable electrical signal—Noise comes from external
sources such as the AC power line, motors, generators,
transformers, fluorescent lights, CRT displays, computers,
electrical storms, welders, radio transmitters, and internal sources
such as semiconductors, resistors, and capacitors. Noise corrupts
signals you are trying to send or receive.
NRSE
nonreferenced single-ended mode—all measurements are made
with respect to a common (NRSE) measurement system reference,
but the voltage at this reference can vary with respect to the
measurement system ground
O
OUT
output pin—a counter output pin where the counter can generate
various TTL pulse waveforms
P
PCI
Peripheral Component Interconnect—a high-performance
expansion bus architecture originally developed by Intel to replace
ISA and EISA. It is achieving widespread acceptance as a standard
for PCs and work-stations; it offers a theoretical maximum transfer
rate of 132 MB/s.
PFI
Programmable Function Input
PFI0/TRIG1
PFI0/trigger 1
PFI1/TRIG2
PFI1/trigger 2
PFI2/CONVERT*
PFI2/convert
PFI3/GPCTR1_SOURCE
PFI3/general purpose counter 1 source
PCI_E.book Page 7 Thursday, June 25, 1998 12:55 PM