Nortel Networks N300 - Manual (Page 40)

aDSL2+/3G wireless N300 4-Port modem Router ymL15wN
40 www.netcomm.com.au
LaN
This screen allows you to configure the Local Area Network (LAN) interface on your Router.
See the field descriptions below for more details.
Option Description
IP Address Enter the IP address for the LaN interface
Subnet Mask Enter the subnet mask for the LAN interface
Enable IGMP Snooping Enable by ticking the box
Standard Mode: In standard mode, multicast traffic will flood to all bridge ports
when no client subscribes to a multicast group.
Blocking Mode: In blocking mode, the multicast data traffic will be blocked.
When there are no client subscriptions to a multicast group, it will not flood to
the bridge ports.
Enable LAN side Firewall Check box to enable Firewall on LAN
Disable DHCP Server Disables the DHCP server. only to be done if Static IP address is set up
Enable DHCP Server Select Enable DHCP server and enter your starting and ending IP addresses
and the lease time. This setting configures the router to automatically assign IP,
default gateway and DNS server addresses to every DHCP client on your LaN
Enable DHCP Server Relay To relay DHCP requests from the subnet with no DHCP server on it to a DHCP
server on other subnets. DHCP Server Relay is disabled by default. to access
enable DHCP relay, please un-tick NAT enable first, that means to disable NAT
first, and then press save button.
Configure the second IP Address
and Subnet Mask for LAN
Interface Configure a second IP address by ticking the checkbox shown below and enter
the following information:
Enter the secondary IP address for the LaN interface.
Enter the secondary subnet mask for the LAN interface.