Nortel Networks N300 - Manual (Page 56)

aDSL2+/3G wireless N300 4-Port modem Router ymL15wN
56 www.netcomm.com.au
System Log
This function allows you to view system events and configure related options. Follow the steps below to enable and view the System Log.
1: Click Configure System Log to continue.
2: Select the system log options (see table below) and click Apply/Save.
Option Description
Log Indicates whether the system is currently recording events. you can enable or disable event logging.
By default, it is disabled.
Log level Allows you to configure the event level and filter out unwanted events below this level. The events
ranging from the highest critical level “Emergency” down to this configured level will be recorded to the
log buffer on the Router’s SDRAM. When the log buffer is full, the newest event will wrap up to the top
of the log buffer and overwrite the oldest event. By default, the log level is “Debugging”, which is the
lowest critical level. The log levels are defined as follows:
Emergency is the most serious event level, whereas Debugging is the least important. For instance,
if the log level is set to Debugging, all the events from the lowest Debugging level to the most critical
level Emergency level will be recorded. If the log level is set to Error, only Error and the level above will
be logged.
Display
Level Allows you to select the logged events and displays on the View System Log window for events of this
level and above to the highest Emergency level.
Mode allows you to specify whether events should be stored in the local memory, be sent to a remote syslog
server, or to both simultaneously.
If remote mode is selected, the view system log will not be able to display events saved in the remote
syslog server. When either Remote mode or Both mode is configured, the WEB UI will prompt the you
to enter the Server IP address and Server UDP port.
3: Click View System Log. The results are displayed as follows.