5 tilt compensation, Smart-ag installation – Novatel GNSS Receiver and Antenna SMART-AG User Manual
Page 28
28
SMART-AG User Manual Rev 5
Chapter 2
Installation and Setup
2.2.5
Tilt Compensation
The SMART-AG Tilt Compensation feature corrects for errors in position caused by tilting of the
vehicle.
To fully install and set up tilt compensation:
1. Mount the SMART-AG on the vehicle.
2. Measure, set, and save the height of the SMART-AG from the ground.
3. Level the tilt sensor and save the data.
2.2.5.1 Physical Installation
The SMART-AG must be mounted as close to the centre of the vehicle as possible, as illustrated in
Figure 6.
Figure 6: SMART-AG Installation
Refer to Tilt Compensation on Page 40 for a detailed description of the Tilt
Compensation feature.
Refer to $PMDT Configure Tilt Compensation on Page 76 for height, level and
update commands.
SMART-AG