Novatel GNSS Receiver and Antenna SMART-AG - Manual (Page 61)

SMART-AG User Manual Rev 5 61
A.2.1 SMART-AG Power/Communications Development Kit Cable
(01018256)
The SMART-AG cable that accompanies the SMART-AG Development Kit, see Figure 28 below,
provides a means of supplying power from a battery while operating in the field. The exposed wires
(red for positive and black for negative) can then be connected to a 12 or 24V vehicular power circuit
(or equivalent) protected by a 5A fast blow fuse (user supplied). The cable also has two DB-9
connectors. One can accommodate a computer serial (RS-232) communication port and the other can
connect to a modem or radio transmitter to propagate differential corrections (please refer to your
user-supplied modem or radio transmitter user guide for more information on its connectors).
In addition, there are a number of bare wires where the outer insulation is cut away but the wires
beneath are intact. See Table 6 on Page 62 for their pinouts. For more information on mating
connectors and part numbers, see Table 7 on Page 63.
This cable is RoHS compliant and its part number is 01018256.
Figure 28: SMART-AG Development Kit Cable
J2
J3
J1
0.500 SCALE
SEE DETAIL A
SEE DETAIL B
RED,
BATT +
BLACK
BATT-
STRIP INSULATION FROM
12 WIRES AND CRIMP AMP/TYCO
TERMINAL # 770520-3 OR 770854-3
PER TYCO APPLICATION SPEC
114-16016
1.000 SCALE
A DETAIL
BLUE,
ER_OUT
WHT-BLK,
ER GND
WHITE, MKI
WHT-BLK,
MKI GND
ORANGE, PPS
WHT BLK,
PPS GND
YELLOW,
CAN1+
GREEN,
CAN1-
1.000 SCALE
B DETAIL
PIN 1
PIN 2
PIN 6
PIN 9
PIN 10
PIN 14
SEE DETAIL C
1.000 SCALE
C DETAIL
PIN 5
PIN 1
PIN 9
PIN 6
COM 1
COM 2
5A Fast Blow Fuse
(User Supplied)
5