Network Technologies 900GV - Manual (Page 32)

Setup Port Signaling Standards
3-2 Installing the Setup Port Cable
Setup Port Signaling Standards
Signals from the MultiSwitch 900 Chassis Manager setup port conform to the EIA-
232D signaling standard at 9600 baud. To the user, the port appears as a data terminal
equipment (DTE) device.
The MultiSwitch 900 Chassis Manager setup port is compatible with devices that use
the EIA-423 signaling standard.
Setup Port Device Cabling
The setup port (Figure 3-1) on the DIGITAL MultiSwitch 900 chassis can be
connected to a setup port device (a terminal or personal computer) by using the
following cables and adapters:
1
xx indicates cable length in meters
For further information on available connectors pin assignments, and adapters used
with this product, refer to Appendix B.
If the setup port device is… Use this cable… With this adapter…
PC with a 9-pin D-sub
communications port
BN24H-xx 1 H8571-J
Terminal with a 25-pin D-sub
connector
BN24H-xx 1 H8575-A
Terminal with a 6-pin MMJ
connector BN24H-xx 1 Not required