Network Technologies 900GV - Manual (Page 43)

Configuring the Module in a DIGITAL MultiSwitch 900 4-9
[4] Configure IP
[4] Configure IP
This option provides you with IP configuration selections.
NOTE
For any of the IP Configuration menu options to take effect, the module needs to
be reset. Use
[2] Restart with Current Settings from the
VNswitch 900GV INSTALLATION MENU . Allow approximately 1 minute
for the module to restart and complete self-test. (Because this option restarts only
the module, and leaves storage parameters configured at their current values, the
module’s restart process takes only 1 minute.)
The following example shows the dialog associated with this option:
The following pages describe the IP Configuration options:
Topic Page
[1] Set SNMP Read/Write Community 4-11
[2] Add SNMP Trap Addresses 4-12
VNswitch 900GV - slot 3
=========================================================
IP CONFIGURATION
[1] Set SNMP Read/Write Community
[4] Set In-Band Interface IP Address
[6] Set Default Gateway
[7] Return to Main Menu
Enter selection number : n <Return>
[5] Set Out-of-Band Interface IP Address
* * * * * * * * * * * * * * * * * * * * * * * * * * *
* Configuration will not take effect until module is *
* restarted. *
* * * * * * * * * * * * * * * * * * * * * * * * * * *
=========================================================
[3] Delete SNMP Trap Address
[2] Add SNMP Trap Address