Network Technologies 900GV - Manual (Page 38)

[9] Start Redirect Mode
4-4 Configuring the Module in a DIGITAL MultiSwitch 900
[9] Start Redirect Mode
The Start Redirect Mode option redirects the DIGITAL MultiSwitch 900
Chassis Manager setup port to the setup port of any network module (such as the
DIGITAL VNswitch 900GV) that is installed into the MultiSwitch 900. This option
allows you to configure or obtain status of an installed network module by accessing
the specified network module’s installation menu.
After you choose the Start Redirect Mode option from the DIGITAL
MultiSwitch 900 INSTALLATION MENU , the screen prompts you for a slot
number, as shown in the following example. After you enter the number of the slot in
which the DIGITAL VNswitch 900GV is installed, the console is redirected to this
slot.
NOTE
The slot number may change to reflect the slot number in which your module is
installed.
The following example shows you how to redirect the console to a specific slot:
If the redirection is successful, after you press Return, the VNswitch 900GV
INSTALLATION MENU appears on your screen. If redirection is not successful, for
example, you entered a number for an empty slot, you can press Return to start again
at the
DIGITAL MultiSwitch 900 INSTALLATION MENU .
Enter the slot number for redirection (1-8): 3 <Return>
Console redirected to 3: VNswitch 900GV
Attempting connection [Ctrl/C to Abort]...