Network Technologies 900GV - Manual (Page 48)

[4] Configure IP
4-14 Configuring the Module in a DIGITAL MultiSwitch 900
[4] Set In-Band Interface IP Address
This option prompts you to change or enter the module’s in-band IP address, subnet
mask, and default gateway for the in-band interface. If an IP address was previously
configured, the screen displays an in-band IP address. The factory default setting is no
in-band address.
You do not need to configure the module with a subnet mask for SNMP
communications with management stations located on the same subnet as the module.
The following example shows the dialog associated with this option:
NOTE
If Routing is enabled, you will be asked to supply an IFC number prior to entering an
IP address.
================================================================
IN-BAND INTERFACE IP ADDRESS CONFIGURATION
example: 16.20.40.156
To delete the IP address, enter 0 in the appropriate address
Interface IP Address Subnet Mask Other Info
In-Band 16.20.216.91 255.255.255.0 08-00-2B-A3-CD-08
OBM Port 16.20.66.156 255.255.255.0 Speed 9600 bps
Enter the IP address [16.20.126.24] : 16.20.54.156 <Return>
Enter the Subnet Mask [255.0.0.0] : 255.255.0 0 : <Return>
.
Press Return for IP Configuration Menu.....
Format: The standard 4 octet dotted decimal notation in which
octet of the address is represented as a decimal
by a ’.’ character.
each
value, separated
================================================================
field.
VNswitch 900GV - slot 3