Chapter 3: identifying external components, Front panel, Front panel rear panel – NetComm NP3024 User Manual
Page 11
YML711 Rev1
NetComm 16 or 24 port Gigabit Switch
www.netcomm.com.au
11
Chapter 3: Identifying External Components
This chapter describes the front panel, rear panel, and LED indicators of the Switch.
Front Panel
The figure below shows the front panels of the 16-Port Switch and the 24-Port Switch.
Front panel of 16-port Gigabit Ethernet Switch
Front panel of 24-port Gigabit Ethernet Switch
LED Indicator:
Comprehensive LED indicators display the status of the
switch and the network (see the following LED Indica-
tors section).
Gigabit Ethernet Ports (1~16 or 1~24):
Depending on which model you have purchased, the
Switch has 16 or 24 Gigabit twisted pair ports, supported
auto negotiable 10/100/1000Mbps and auto MDI/MDIX
crossover detection function. This supplies true “plug
and play” capability. These ports operate in half-duplex
mode for 10/100Mbps and full- duplex mode for 10/100/
1000Mbps.
Note:
When the port is set to “Forced Mode”, the Auto MDI/MDIX feature will be
disabled.