NetComm NP3024 - Manual (Page 41)

YML711 Rev1 NetComm 16 or 24 port Gigabit Switch
www.netcomm.com.au 41
Legal & Regulatory Information Copyright Information
This manual is a copyright protected work. Apart from any fair dealing exceptions for the purposes
of private study, research, criticism or review, as permitted under the Australian Copyright Act 1968
(Cth), no part of this manual may be reproduced, stored in a retrieval system or communicated,
published, performed or adapted in any form, by any means, be it electronic, mechanical, recording
or otherwise, without the prior written permission of NetComm. NetComm accepts no liability or
responsibility, for consequences arising from the use of this product or manual.
NetComm reserves the right to change the specifications and operating details of this product and
manual without notice and does not warrant that any changes to the specifications or operating
details of the product will meet the requirements of the customer or will be able to interoperate,
remain compatible or coexist with any other hardware or software the customer uses.
Registration of warranties, either via the NetComm web site or via post is subject to NetComm’s
privacy policy and procedures. Copies of NetComm’s privacy policy and procedures can be
obtained from www.netcomm.com.au.
Customer Information
ACA (Australian Communications Authority) requires you to be aware of the following information
and warnings in relation to the purchased product:“
(I) This unit shall be connected to the Telecommunication Network through a line cord which meets
the requirements of the ACA TSOOS Standard.“
(2) This equipment has been tested and found to comply with the Standards for C-Tick and or A-
Tick as set by the ACA. These standards are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio noise and, if not installed and used in accordance with the instructions detailed within this
manual, may cause interference to radio communications. However, there is no guarantee that
interference will not occur with the installation of this product in your home or office. If this
equipment does cause some degree of interference to radio or television reception, which can be
determined by turning the equipment off and on, we encourage the user to try to correct the
interference by one or more of the following measures:
• Change the direction or relocate the receiving antenna.
• Increase the separation between this equipment and the receiver.
• Connect the equipment to an alternate power outlet on a different power circuit from
that to which the receiver/TV is connected.
• Consult an experienced radio/TV technician for help.
(3) The power supply that is provided with this unit is only intended for use with this product. Do
not use this power supply with any other product or do not use any other power supply that is
not approved for use with this product by NetComm. Failure to do so may cause damage to this
product, fire or result in personal injury.