Trap setting, Set password – NetComm NP3024 User Manual
Page 31
YML711 Rev1
NetComm 16 or 24 port Gigabit Switch
www.netcomm.com.au
31
Trap Setting
The Trap Setting enables the device to monitor events through the Web Management Utility, and to
set the Trap IP Address where the trap event information is to be sent.
Figure 26. Trap Setting
System Events :
Monitoring the system’s trap.
Device Bootup :
A trap is hit when booting up the system.
Illegal Login
:
A trap is hit when a user tries to log in using an incorrect
password, and it will record the IP address where the
incorrect login occured.
Twisted Pair Port Events:
Monitoring the copper port status.
Abnormal* Receive Error:
A trap where there was a receive data error in the copper
port.
Abnormal* Transmit Error:
A trap where there was a transmit data error in the copper
port.
* Abnormal is a 50 error packet count within 10 seconds.