NetComm NP3024 - Manual (Page 12)

NetComm 16 or 24 port Gigabit Switch YML711 Rev1
12 www.netcomm.com.au
Rear Panel
Figure 4. Rear panel of the Switch
Power Switch: The Power Switch controls the power to the unit and can
be turned on after the power cable is connected.
AC Power Connector: This is a three-pronged connector that supports the
power cord. Plug in the female connector of the provided
power cord into this connector, and the male into a
power outlet. Supported input voltages range from 240V
AC at 50Hz.
Reset: The Reset button will restore the unit to its factory
defaults.
Note: Be sure that you record your Switch’s settings before pressing the Reset
button, as any changes to the default will be lost.