Diagnostic push button, Led indicators, Step 2 - configuring your mini print server – NetComm Fast Ethernet Mini Print Server NP3640 User Manual

Page 5

Advertising
background image

Rev. 1 - YML656

www.netcomm.com.au

NP3640 Fast Ethernet Mini Print Server

Page 5

Diagnostic Push Button

The Print Server is fitted with a Diagnostic Push Button. The button is recessed; a pin or paper
clip can be used to press it. This button has 2 functions:

Restore the factory default settings

Print a test page containing all current settings.

To restore the factory default settings:

1. Turn the Print Server OFF.

2. Press and hold the diagnostic button. While pressing the button, switch the Print Server ON.

3. If you continue pressing the button for 10 seconds, a diagnostic page will be printed,

showing the new (default) settings.

To generate a Diagnostic print out

1. Ensure that both the Print Server and the printer attached to port 1 are ON.

2. Press the diagnostic button, and hold it in for 2 seconds.

3. The test page, containing the current settings, will be printed.

Note: PostScript printers are unable to print this page. If you have a PostScript printer on

Port 1, the test page will not be printed.

LED Indicators

The Mini Print Server has four LED indicators; status, error, 10 BaseT and 100BaseT. The
LED indicator modes are described in the following table:

Green LED

Red LED

Description

Off

Off

No power.

Off

On

Printer not on.

On

On

Hardware error.

Flashing

Flashing

Firmware upgrade in progress.

On

Off

Normal operation.

Flashing

Off

Normal operation - transmitting or receiving packets
from the network.

Yellow LED

Orange LED

Description

On

Off

Connected at 10BaseT.

Off

On

Connected at 100BaseT.

Advertising