NetComm NP2500 User Manual
Page 39
NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide
39
YML842 Rev1
Operating: 0
o
~ 40
o
C (32
o
~ 104
o
F), Storage: -10
o
~ 70
o
C (14
o
~ 158
o
F)
Humidity
Operating: 10% ~ 90%, Storage: 5% ~ 90%
Dimensions
440 x 310 x 44 mm
EMI:
FCC Class A, CE Mark Class A, VCCI Class A
Safety:
cUL(UL60950), CB(IEC60950)
Performance
Transmits Method:
Store-and-forward
Filtering Address Table:
4K entries per device
Packet Filtering/Forwarding Rate:
10Mbps Ethernet: 14,880/pps
100Mbps Fast Ethernet: 148,800/pps
1000Mbps Gigabit Ethernet: 1,488,000/pps
MAC Address Learning:
Automatic update
Transmits Method:
Store-and-forward
RAM Buffer:
768K bytes per device
WARNINGS
FCC Warning
This equipment has been tested and found to comply with the regulations for a Class A digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with this user’s guide,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be required to correct the interference at his
or her own expense.
CE Mark Warning
This is a Class A product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
VCCI Warning
This is a product of VCCI Class A Compliance.
UL Warning
a) Elevated Operating Ambient Temperature- If installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than room ambient. Therefore,
consideration should be given to installing the equipment in an environment compatible with the manu-
facturer’s maximum rated ambient temperature (Tmra).
b) Reduced Air Flow- Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.