Advanced ip/ipx router configuration options, Connection profiles, Advanced ip/ipx router configuration options -8 – Netopia R5300 User Manual
Page 108: Connection profiles -8
9-8 User’s Reference Guide
A
A
A
Ad
d
d
dvvv
vaa
a
an
n
n
nccccee
e
ed
d
d
d IIIIP
P
P
P////IIIIP
P
P
PX
X
X
X rrrro
o
o
ou
u
u
uttttee
e
errrr cccco
o
o
on
n
n
nffffiiiig
g
g
gu
u
u
urrrraa
a
attttiiiio
o
o
on
n
n
n o
o
o
op
p
p
pttttiiiio
o
o
on
n
n
nssss
Advanced users can optionally use connection profiles to configure the IP and IPX protocol stack inter faces on
the WAN link. You need not explicitly define these parameters, however. The following information is provided as
reference to the possible router configurations advanced users may desire.
The IP router inter face on the WAN link:
■
may be numbered or unnumbered.
■
may or may not use Network Address Translation (NAT).
■
will attempt to autoconfigure itself without an explicitly configured connection profile, if permitted to do so
by the setting of the Must Match a Defined Profile item in the Default Profile screen. See
The link up process at the inter face between the WAN data link encapsulation module and the IP router
functions as follows:
■
When the WAN data link comes up, the router will search for a configured connection profile that specifies
WAN encapsulation.
■
If more than one WAN profile exists, the router will use the first such profile.
■
If no WAN profile exists, and the Must Match a Defined Profile field in the Default WAN Profile is set to No,
the router will construct a Default Profile, and the link up process will continue using this constructed
profile as if it were an explicitly configured one.
■
If no WAN profile exists, and the Must Match a Defined Profile field in the Default WAN Profile is set to Yes,
IP will not come up on the WAN link. The router will log an “IP connection refused” event in the WAN Event
Histor y.
■
If a WAN profile exists (or a default one has been constructed), the router will attempt to configure its
inter face on the WAN link using the information stored in the profile.
C
C
C
Co
o
o
on
n
n
nn
n
n
nee
e
eccccttttiiiio
o
o
on
n
n
n P
P
P
Prrrro
o
o
offffiiiillllee
e
essss
Since you will probably only have a single connection to your ISP over the WAN link, you may not need to create
multiple connection profiles. Multiple connection profiles are useful on leased (unswitched) inter faces only to
suppor t meshed WAN connections. If you do not intend to set up meshed WAN connections, you do not need to
create multiple connection profiles.
Connection profiles may be used to define the connection information for your WAN Auxiliar y Por t access.
Connection profiles define the line and networking protocols necessar y for the router to make a remote
connection. A connection profile is like an address book entr y describing how the router is to get to a remote
site, or how to recognize and authenticate a remote user dialing in to the router. For example, to create a new
Connection Profile, you navigate to the WAN Configuration screen from the Main Menu, and select Add
Connection Profile.