Netopia R5300 User Manual
Page 123
IP Setup and Network Address Translation 9-23
Go to the System Configuration screen. Select IP Address Serving and press Return. The IP Address Ser ving
screen will appear.
Follow these steps to configure IP Address Ser ving:
■
If you enabled IP Address Ser ving, then DHCP, BootP clients, Dynamic WAN clients, and MacIP/KIP clients
(if you have the AppleTalk kit installed) are automatically enabled.
■
Select Number of Client IP Addresses and enter the total number of contiguous IP addresses that the
Netopia R5000 Series Router will distribute to the client machines on your local area network. Twelve-user
models are limited to twelve IP addresses.
■
In the screen example shown above, five Client IP addresses have been allocated.
■
Select 1st Client Address and enter the first client IP address that you will allocate to your first client
machine. For instance, on your local area network you may want to first figure out which machines are going
to be allocated specific static IP addresses so that you can determine the pool of IP addresses that you will
be ser ving addresses from via DHCP, BootP, Dynamic WAN, and/or MacIP.
Example: Your ISP has given your Netopia R5000 Series Router the IP address 192.168.6.137, with a
subnet mask of 255.255.255.248. The subnet mask allocated will give you six IP addresses to use when
connecting to the ISP over the Internet (for more information on IP addressing refer to
“Understanding IP Addressing.”
). Your address range will be from .137-.143. In this example you would
enter 192.168.6.138 as the 1st Client Address, since the router itself must have an IP address.
■
To enable DHCP, select Serve DHCP Clients and toggle it to Yes. DHCP ser ving is automatic when IP
Address Ser ving is enabled.
IP Address Serving
Number of Client IP Addresses: 5
1st Client Address: 176.163.222.10
Client Default Gateway... 176.163.222.1
Serve DHCP Clients: Yes
DHCP NetBios Options...
Serve BOOTP Clients: Yes
Serve MacIP/KIP Clients: Yes
MacIP/KIP Static Options...