Netopia R5300 - Manual (Page 143)

AppleTalk Setup 11-7
Series Router’s EtherTalk Phase II por t is visible to other AppleTalk nodes. The default zone is also where
new AppleTalk nodes will appear. If you do not set a default zone, the first zone you create will be the
default zone.
■ You can also set the range of EtherTalk Phase II network numbers. Select Net Low and enter the lower limit
of the network number range. Select Net High and enter the upper limit of the range.
■ Select the Seeding pop-up menu and choose the seeding method for the Netopia R5000 Series Router to
use. (See
“Routers and seeding” on page 11-3 ).
You have finished configuring EtherTalk Phase II.
LLL Lo o o occccaa a allllTT T Taa a allllkk k k ssssee e ettttu u u up p p p
For instructions on making the physical connections for LocalTalk, see “Connecting to a LocalTalk network” on
page 4-5 .
In the AppleTalk Setup screen, select LocalTalk Setup and press Return. The LocalTalk Setup screen appears.
■ If you are using LocalTalk with the Netopia R5000 Series Router, select LocalTalk Enabled and make sure
LocalTalk is set to On, which is the default.
Note: Since the LocalTalk connector attaches to the Auxiliar y por t on the router, that por t will no longer be
available for a third external modem.
■ Select LocalTalk Zone Name and enter a new or existing zone name.
Note: Your LocalTalk network may already have a zone and network number in place. For the Netopia
R5000 Series Router’s LocalTalk por t to be par t of your LocalTalk network, it must have a network number
and zone name that matches the values in use on the LocalTalk network.
LocalTalk Setup
LocalTalk Enabled: On
LocalTalk Zone Name: Unnamed
LocalTalk Net Number: 33126
Seeding... Soft-Seeding
Use this screen to set up the LocalTalk Port Routing attributes.