Netopia R5300 User Manual
Page 134
10-4 User’s Reference Guide
Before changing any of the settings in this screen, consult your network administrator for the IPX setup
information you will need. Changes made in this screen will take effect only after the Netopia R5000 Series
Router is reset.
To go to the IPX Setup screen, from the Main Menu select System Configuration and then select Network
Protocols Setup and then select IPX Setup.
Note: If you have completed Easy Setup, the information you have already entered will appear in the IP Setup
options screen.
1.
To enable IPX routing, select IPX Routing, toggle it to On, and press Return.
2.
To change Ethernet encapsulation from the commonly used 802.3 standard, select Ethernet
Encapsulation and choose a different encapsulation method.
3.
Select Ethernet Network Address and enter the network address of the IPX network connected to the
Netopia R5000 Series Router’s Ethernet por t.
Note: If the Ethernet network address is set to zero, the router will attempt to learn the address from any
configured IPX device on the Ethernet network or from the remote IPX network when a call is established.
4.
To change the default path delay, select Ethernet Path Delay and enter a value (in ticks). This value is used
to determine the por t cost of using the Ethernet por t in IPX RIP calculations.
5.
To enable NetBIOS packet for warding, select Ethernet NetBios Forwarding and toggle it to Yes. This
parameter will determine whether IPX Packet type 20 packets are for warded on the Ethernet inter face.
These packets are used by NetBIOS and some other applications.
6.
Select Ethernet Inbound SAP Filter Set to filter incoming IPX SAP adver tisements on the Ethernet. By
attaching an incoming SAP filter on the Ethernet, you can restrict the number of SAP entries learned on a
large IPX network to only those required by remote users connecting to the Netopia R5000 Series Router.
An Ethernet SAP filter must be used with networks that have so many ser vers adver tised that the Netopia
R5000 Series Router would other wise exhaust its internal memor y storing ser ver entries.
IPX Setup
IPX Routing: On
Ethernet Encapsulation... 802.3
Ethernet Network Address: 00000000
Ethernet Path Delay: 1
Ethernet NetBios Forwarding: No
Ethernet Inbound SAP Filter Set... <<NONE>>
Default Gateway Address: 00000000
Filters and Filter Sets...
IPX Wan Pool Base Address 00000000
Return/Enter accepts * Tab toggles * ESC cancels.
Set up the basic IPX attributes of your Netopia in this screen.