Removing an sfp – Nortel Networks 1000BASE-SX User Manual

Page 28

Advertising
background image

28

Small form factor pluggable transceivers

Figure 4
Wrap-around latch-type extraction mechanism

Removing an SFP

Remove an SFP to replace it or to commission it elsewhere.

Procedure steps

Step

Action

1

Disconnect the network fiber cable from the SFP connector.

2

Affix dust covers over the fiber optic bore and connector.

3

Depending on your SFP model, to release the SFP, press the
locking/extractor mechanism.

Your SFP locking/extractor mechanism can be different than the
models shown.

4

Slide the SFP out of the module SFP slot.

If the SFP does not slide easily from the module slot, use a gentle
side-to-side rocking motion while firmly pulling the SFP from the slot.

5

Store the SFP in a safe place until needed.

ATTENTION

If you discard the SFP, be sure to dispose of it according to all national
laws and regulations.

Nortel Metro Ethernet Routing Switch 8600

Installation — SFP, XFP, GBIC, and OADM Hardware Components

NN46220-301

01.01

Standard

5.0

1 May 2008

Copyright © 2008, Nortel Networks

.

Advertising
This manual is related to the following products: