Nortel Networks 1000BASE-SX - Manual (Page 37)

Installing an XFP 37
Model number Product number Description
NTK587AY-E5 1537.40
NTK587BA-E5 1538.19
NTK587BC-E5 1538.98
NTK587BE-E5 1539.77
NTK587BG-E5 1540.56
NTK587BJ-E5 1541.35
NTK587BL-E5 1542.14
NTK587BN-E5 1542.94
NTK587BQ-E5 1543.73
NTK587BS-E5 1544.53
10GBASE DWDM
NTK587BU-E5 1545.32
Note: Due to hexidecimal to decimal rounding, and vice-versa, the wavelength numbers provided
by the XFP manufacturer and reported by the Metro Ethernet Routing Switch 8600 system may
vary slightly.
Installing an XFP
Install an XFP to provide a 10 Gigabit Ethernet interface between the switch
and other network devices.
Installing an XFP takes about 3 minutes.
Prerequisites
• Verify that the XFP is the correct model for your network configuration.
Procedure steps
CAUTION
Nortel recommends that you install only one 10GBASE-ZR/ZW
per module due to cooling limitations on the 8683XLR and
8683XZR modules. Nortel further recommends the installation of
the XFP only in port 1. You can install a 10GBASE-SR, -LR/LW, or
-ER/EW in one or both of the remaining ports.
CAUTION
XFPs are keyed to prevent incorrect insertion. If the XFP resists
pressure, do not force it; turn it over, and reinsert it.
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, GBIC, and OADM Hardware Components
NN46220-301 01.01 Standard
5.0 1 May 2008
Copyright © 2008, Nortel Networks
.