Nortel Networks 1000BASE-SX - Manual (Page 39)

Removing an XFP 39
Figure 8
XFP with bail lock and extraction mechanism
Removing an XFP
Remove an XFP to replace it or to commission it elsewhere.
Procedure steps
Step Action
1 Disconnect the network fiber cable from the XFP connector.
2 Affix a dust cover over the optical connector.
3 Pull the bail mechanism on the XFP to release the XFP.
4 Slide the XFP out of the module XFP slot.
If the XFP does not slide easily from the module slot, use a gentle
side-to-side rocking motion while firmly pulling the XFP from the slot.
5 Replace the port dust cover or EMI plug in the module.
6 Store the XFP in a safe place until needed.
ATTENTION
If you discard the XFP, be sure to dispose of it according to all national
laws and regulations.
—End—
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, GBIC, and OADM Hardware Components
NN46220-301 01.01 Standard
5.0 1 May 2008
Copyright © 2008, Nortel Networks
.