Nortel Networks 1000BASE-SX - Manual (Page 50)

50 SFP specifications
1000BASE-T SFP specifications
The 1000BASE-T SFP provides Gigabit Ethernet connectivity using a single
eight-pin RJ-45 connector. The 1000BASE-T SFP only operates at 1 gigabit
per second (1 Gbit/s) and does not support 100BASE-T or 10BASE-T
interfaces. The part number for this model is AA1419043-E6.
ATTENTION
You must disable autonegotiation before operating the 1000BASE-T SFP.
By default, SFPs inserted into certain product-specific modules are set for
Autonegotiation = True.
The maximum current requirement of the SFP is 375 milliamperes (mA) at
5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
Table 13
IEEE 802.3z 1000BASE-T SFP specifications
Parameter Specifications
Standards IEEE 802.3z, IEEE 802.3ab
Connectors RJ-45
Cabling CAT5E or better UTP
Distance Up to 100 m
1000BASE-SX (LC) SFP specifications
The 1000BASE-SX SFP provides 1000BASE-SX Gigabit Ethernet
connectivity at 850 nm using multimode optical fiber (MMF). This SFP
supports full-duplex operation only. The part number for this model is
AA1419013-E5.
ATTENTION
AA1419013-E5 continues to be supported. However, it is no longer orderable.
Order AA1419048-E6 as a replacement.
The following table describes standards, connectors, cabling, and distance
for the 1000BASE-SX SFP.
Table 14
IEEE 802.3z 1000BASE-SX (LC) SFP specifications
Parameter Specifications
Connectors Duplex LC
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, GBIC, and OADM Hardware Components
NN46220-301 01.01 Standard
5.0 1 May 2008
Copyright © 2008, Nortel Networks
.