Nortel Networks SRG 50 NN43001-307 - Manual (Page 122)

122 Bandwidth Management
Command Description
Change the QoS Response Time Interval while alarms are not coming, in order
to increase the Sliding Maximum for the identified zone, where:
• Zone = 1-255
• Interval = interval in minutes = 1-(5)-120
CHG ZQUAT <Zone> <Thres>
Change the QoS Unacceptable Alarm Threshold value for the identified zone,
where:
• Zone = 1-255
• Thres = threshold value = 1-(75)-99
When the zone-to-zone QoS value drops below the threshold value, the alarm
is presented. When the zone-to-zone QoS value is greater than this threshold
value, this alarm is presented as being deactivated. This value must be below
the value of ZQWAT.
CHG ZQWAT <Zone> <Thres>
Change the QoS Warning Alarm Threshold value for the identified zone, where:
• Zone = 1-255
• Thres = threshold value = 1-(85)-99
When the zone-to-zone QoS value drops below the threshold value, the alarm
is presented. When the zone-to-zone QoS value is greater than this threshold
value, this alarm is presented as being deactivated. The value for ZQWAT must
be higher than the value of ZQUAT.
NEW ZONE <zoneNumber> [<intraZoneBandwidth> <intraZoneStrategy> <interZoneBandwidth>
<interZoneStrategy> <zoneIntent> <zoneResourceType>]
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
Copyright © 2005-2007, Nortel Networks
.