Nortel Networks SRG 50 NN43001-307 - Manual (Page 49)

Configuring the dialing plan for PSTN access to SRG users in Normal Mode 49
• Configure the NRS—see Procedure 4 "Configuring the NRS database"
(page 57) .
1. Access NRS Manager.
2. Select an endpoint.
3. Configure the Numbering Plan Entry for the branch office.
• At the branch office—see Procedure 5 "Configuring the branch office"
(page 60) .
1. Configure the Route List Index.
2. Configure ESN.
These steps can be done using overlays, as described in this section, or in
Element Manager and NRS Manager. See IP Peer Networking Installation
and Commissioning (NN43001-313) for more details.
Procedure 3
Configuring the main office
Step Action
1 Configure the ZACB property for the branch office zone.
LD 117 Define the zone Access Code handling for the branch office zone
Command Description
CHG ZACB <zone> [ALL]|[<AC1|AC2> <AC1|AC2>]
Define the Access Codes used to modify local or long-distance
calls in the branch office to force all branch office calls to be
routed to the MG 1000B PSTN.
The ZACB and ZDP properties are used to configure the digit
manipulation behavior of the branch office zone (see step 2).
The ZACB property specifies which calls undergo digit manipulation.
The attribute can be configured in the following ways:
• CHG ZACB <zone>
In this configuration, dialing AC1 or AC2 does not trigger digit
manipulation. SRG user calls are treated exactly the same as
those for main office users.
• CHG ZACB <zone> ALL
In this configuration, calls dialed with AC1 and calls dialed with
AC2 undergo zone-based digit manipulation. All SRG user calls
can then be routed to the SRG PSTN.
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
Copyright © 2005-2007, Nortel Networks
.