Network Technologies SM-nXm-15V-LCD - Manual (Page 34)

NTI VEEMUX VIDEO MATRIX SWITCH
30
1 2 3
4 5 6
7 8 9
0 OUT IN
SYS
Lo Batt
NTI
R
Network Technologies Inc
IRT-64X32
SW
INFRARED CONTROL
(Optional)
The IRT-64X32 (or IRT) is an infrared remote transmitter that enables the user to control up to four (4) NTI VEEMUX Video Matrix
switches via an infrared receiver from up to 50 feet away (with an unobstructed view). The IRT is battery-powered and always
ready to use. The IRT will have a blank display unless an action is being selected by the user. The IRT enables the user to
make connections between any input (video source) and any output (display device) on up to four (4) separate switches
.
Note: Multiple switches that are located close to each other and are to be individually controlled must be pre-configured
(by NTI) to be identified by the IRT as switches #1, #2, #3, or #4. Please ask your salesperson to have switches
configured accordingly at time of order. Unless otherwise specified, by default, all IRT-enabled switches will be
configured as switch #1.
Materials included:
•
IRT-64X32 Infrared Remote Transmitter for video matrix switches
•
(2) AA Cell Batteries- installed
Features And Functions
Keypad
¾ Buttons Numbered 0-9 – Used for port selection
¾ OUT – Pressed to validate and transmit the Output selection
¾ IN – Pressed to validate and transmit the Input selection
¾ SYS – Pressed to choose the switch to be controlled or to configure the maximum
number of inputs/outputs
LCD Display
¾ The first digit of the LCD will display the number of the switch to be controlled followed by the decimal point. This way the
user will always know which switch will be affected by the IRT.
¾ The last two digits in the LCD represent 1) the desired input or output port to be connected or 2) the desired switch to be
controlled when changing switches.
¾ The "Lo Batt" decimal point will illuminate when the user should change the batteries.
¾ The LCD will automatically power-down after 30 seconds of non-use and power-up with the press of any button.
Lo Batt SW
Represents Input or
Output
Represents switch to be controlled